Archive for the ‘Kyosho Mini-Z Racer’ Category
Kyosho Mini-Z Ferrari 430GT Front Body Mount
12, Apr 2015
We have broken the front body holder of a Ferrari 430GT body for Mini-Z MR-03 model, so we had to either find a new replacement or make one ourselves. So here is a replacement 3D printable front body mount for the Ferrari 430GT body for Kyosho Mini-Z RC models. You can print and use this replacement if your stock front body mount breaks like in our case and you cannot find an original replacement or don’t want to wait for such to arrive. The body holder should be a perfect fit and provide enough strength and durability, just like the original. We recommend to use 0.1mm layer height for best results and the use of support structure as some part of the body mount is in the air and it will not be useable if don’t use supports.
– To download the 3D printable Kyosho Mini-Z Ferrari 430GT Front Body Mount…
The Audi R8 LMS body for Kyosho Mini-Z RC cars is designed for use with 98mm AWD Mini-Z chassis such as MA-10 or MA-20 and is not intended for MR-02 or MR-03 RWD Mini-Z models, even though it will fit on them as well. When using the Audi R8 LMS body with a rear wheel drive Mini-Z RC model you will notice that the side body clips are not fitting tight over the chassis like they do on the AWD chassis. We have addressed this issue with a custom 3D printable side body clips for use of the Audi R8 LMS body on MR-02 and MR-03 chassis removing the chassis play inside the body. We are already using these on a Mini-Z MR-03 chassis with Audi R8 LMS body and our 3D printable body clips work great.
– To download the 3D printable Body Clips for Audi R8 LMS Body for Mini-Z MR-02/MR-03…
Kyosho Mini-Z MR-02/MR-03 Wheels (0 offset)
9, Apr 2015
Just a quick try to make usable 3D printed wheels for Kyosho Mini-Z RC car, these are for MR-02 or MR-03 models, will not fit on AWD. Standard wheels with 0 offset, front and rear wheel. Do note this is a work in progress as it needs a little bit of fine tuning on the inside where you place plastic bushings or bearings. You need to print with finer resolution such as 0.1mm for best results and use support material for the inside to print well.
– To download the 3D printable Kyosho Mini-Z MR-02/MR-03 Wheels (0 offset)…